BRP Evinrude E-TEC G2 - Page 33

33
1
2
3
4
5
CCOONNCCEEAALLEEDD SSIIDDEE MMOOUUNNTT CCOONNTTRROOLL
1. Handle – shift and throttle
2. Trim/tilt switch (where equipped)
3. Neutral lock lever
4. Fast idle button (warm-up)
5. Throttle friction adjusting screw
2
1
3
4
5
SSIINNGGLLEE LLEEVVEERR BBIINNNNAACCLLEE MMOOUUNNTT
CCOONNTTRROOLL
1. Handle – shift and throttle
2. Trim/tilt switch (where equipped)
3. Fast idle button (warm-up)
4. Throttle friction adjusting screw (under
cover)
5. Engine cut–off switch clip and tether cord
3
2
1
1
4
DDUUAALL LLEEVVEERR BBIINNNNAACCLLEE MMOOUUNNTT
CCOONNTTRROOLL
1. Handle – shift and throttle
2. Trim/tilt switch (where equipped)
3. Fast idle button (warm-up)
4. Throttle friction adjusting screw (under
cover)
SShhiiffttiinngg
With the engine running and the con-
trol handle in the NEUTRAL position:
SSiiddee MMoouunntt CCoonnttrroollss
Unlock the control handle by lifting the
neutral lock lever on the hand grip.
Move the control handle with a firm,
quick motion, forward or aft until it en-
gages the forward or reverse gear
detent.
OPERATION