BRP Evinrude - Page 38

36
OUTBOARD INSTALLATION
TRANSOM MEASURING AND DRILLING
Drilling and Hardware Diagrams
75–300 HP, ALL MODELS; 40–60 HP, POWER TRIM MODELS; 25–30 HP, POWER TRIM MODELS
IMPORTANT: This is not a template.
Quantity
1. Center of Transom 5. Bolt * 4
* Choose from the following bolt sizes:
2. Top of Transom 6. 318272 Plate 2 327053 3 in. (76 mm)
3. 1/2” Bolt Hole Locations 7. 318273 Retainer 2 318573 3 1/2 in. (89 mm)
4. Outside of Transom 8. 319886 Screw 4 336676 4 1/2 in. (114 mm)
9. 307238 Washer 2 331578 5 in. (127 mm)
10. 320248 Washer 4 354101 6 in. (152 mm)
11. 313623 Nut 4 354102 7 in. (178 mm)
12. 318572 Cap 4 354103 8 in. (203 mm)
354104 9 in. (229 mm)
3
2
2
3
1
3
3
1
2 in.
(50.8mm)
8 in.
(203.2mm)
8 in.
(203.2mm)
4 15/16 in.
(125.4mm)
4 15/16 in.
(125.4mm)
6 7/16 in.
(163.5mm)
6 7/16 in.
(163.5mm)
2 in.
(50.8mm)