81
FUEL AND OIL PRIMING
OIL SUPPLY PRIMING
4
Use the Prime Oil System button of the Dynamic
Test screen to prime the oil pump.
Observe oil flow through all oil distribution hoses.
Air must be purged during the priming procedure.
Make sure that oil flows through the rear oil distri-
bution manifold to the cylinder block fittings.
Small bubbles are acceptable. Large bubbles
must be eliminated through continued priming.
Repair any fuel or oil leaks.
The oiling system on these models can also be
primed using the Self-Winterizing feature if diag-
nostics software is not available. Refer to Opera-
tor’s Guide.
Dynamic Test Screen
1. Prime Oil System button
008570
90° V6 Models
1. Oil distribution hoses
004224
60° V4–V6 Models
1. Oil distribution hoses
004965
1. Rear oil distribution manifold 008016
1. Oil distribution hose
2. Small bubbles
3. Large bubbles
004398
To Next Page
Loading...
