BRP ROTAX 916 i A Series Maintenance Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
Exceeding up to max. 160 °C (320 °F)
Table 3: Excess temperature up to max. 160 °C (320 °F) max. 15 min.
Step
Procedure
1 The whole oil system must be inspected, repaired or overhauled according
to the BRP-Rotax instructions for continued airworthiness.
2 Inspect oil level in the oil tank.
3
Inspect oil cooler for contamination and check the entire oil circuit for cor-
rect functioning.
4
Check that oil lines are routed correctly and undamaged.
5
Cut oil filter housing and inspect filter mat for foreign matter.
6 Carry out oil change.
7
Inspect all further systems for correct functioning.
Exceeding over 160 °C (320 °F)
Table 4: Excess temperature over 160 °C (320 °F) and/or the operating limit for
longer than 15 min.
Step
Procedure
1 The whole oil system must be inspected, repaired or overhauled according
to the BRP-Rotax instructions for continued airworthiness.
2 Inspect all further systems for correct functioning.
3
Carry out detailed inspection of the affected engine components.
4
The whole oil system (oil cooler, oil lines) must be inspected.
5
Cut oil filter housing and inspect filter mat for foreign matter.
6
Carry out oil change.
OIL PRESSURE BELOW MINIMUM VALUE
General note
NOTICE
If the oil pressure falls below the minimum value, other limits are often exceeded,
e.g. the oil temperature. Please observe the relevant instructions.
NOTE
Any exceeding of the min. admissible oil pressure must be entered by the pilot in-
to the engine log book, stating duration and extent of pressure loss and pertinent
details.
05–50–00
Page 34
December 01 2023
Effectivity: 916 i A / C24
Edition 0/Rev. 1

BRP ROTAX 916 i A Series Specifications

General

Brand	BRP
Model	ROTAX 916 i A Series
Category	Engine
Language	English