BRP-Rotax
MAINTENANCE MANUAL LINE
Figure 5.25: Lowest positioned screws
Longer than 5 hr. If the engine has been operated longer than 5 hours with engine oil not corresponding
with specification in the Operators Manual (OM) the following work is required.
Oil specification not respected
Step
Procedure
1 Remove propeller gearbox.
2 The gearbox must be inspected, repaired or overhauled according to the
BRP-Rotax instructions for continued airworthiness.
3
Carry out detailed inspection of the affected engine components.
4
Carry out an oil change.
5
Remove the lowest positioned banjo screw (banjo bolt, plug screw or screw
socket) and drain the remaining oil from the crankcase. Re-install banjo bolt
or plug screw.
Tightening torque see Installation Manual (IM) for the respec-
tive engine type.
6 Replace oil filter.
05–50–00
Page 38
December 01 2023
Effectivity: 916 i A / C24
Edition 0/Rev. 1
To Next Page
Loading...
