BRP ROTAX 916 i A Series Maintenance Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
OIL SPECIFICATION NOT RESPECTED
General note
NOTE
An entry by the pilot in the engine log book of all pertinent details is required.
If by error engine was serviced with oil, which does not correspond with oil specification in
the Operators Manual (OM) and the engine has been in operation for less than 5 hours,
the following measures must be taken:
Less than 5 hr.
Oil specification not respected
Step
Procedure
1 Carry out an oil change.
2
Remove the lowest positioned screw (banjo bolt, plug screw or screw sock-
et) and drain the remaining oil from the crankcase. Re-install banjo bolt or
plug screw.
Tightening torque see Installation Manual (IM) for the respec-
tive engine type.
3 Replace oil filter.
4
Drain oil completely from oil cooler and oil hoses.
5
Drain oil from oil tank.
6 Refill oil tank with oil as specified, refer to Operators Manual (OM) for the
respective engine type.
7
Purge air from oil system.
See Chapter 12-20-00 section Purging the oil system.
8 Run engine for approx. 1 hour and replace oil and oil filter once more, see
Chapter 12-20-00 section Oil change.
Effectivity: 916 i A / C24
Edition 0/Rev. 1
05–50–00
Page 37
December 01 2023

BRP ROTAX 916 i A Series Specifications

General

Brand	BRP
Model	ROTAX 916 i A Series
Category	Engine
Language	English