BRP ROTAX 916 i A Series Maintenance Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
Table 5: Oil pressure below minimum permissible oil pressure up to max. 0.5 bar
(7.25 psi) max. 1 min. in flight
Step
Procedure
6
If no cause for the low oil pressure is found after the above checks, carry
out an oil change.
7
If after the previous checks and oil change the oil pressure is still too low,
repair or overhaul the engine in accordance with the BRP-Rotax instruc-
tions for continued airworthiness.
8
Inspect all systems for correct functioning.
9 Carry out detailed inspection of the affected engine components.
NOTICE
Replace the oil cooler and oil lines. Before the re-installation of the engine the
complete lubrication system (inclusive oil tank) must be flushed.
Minimum oil pressure in flight lower then 0.5 bar (7.25 psi).
Consequent damage can be expected if the oil pressure falls below the minimum value by
more than 0.5 bar (7.25 psi). See current Operators Manual (OM).
Table 6: Oil pressure below minimum permissible value more than 0.5 bar (7.25
psi) in flight
Step
Procedure
1 The whole cooling system must be inspected, repaired or overhauled in ac-
cordance with the BRP-Rotax instructions for continued airworthiness.
• The crankshaft must be replaced.
2 Carry out detailed inspection of the affected engine components.
3
Cut oil filter housing and inspect filter mat for foreign matter.
4
Inspect all further systems for correct functioning.
05–50–00
Page 36
December 01 2023
Effectivity: 916 i A / C24
Edition 0/Rev. 1

BRP ROTAX 916 i A Series Specifications

General

Brand	BRP
Model	ROTAX 916 i A Series
Category	Engine
Language	English