BRP-Rotax
MAINTENANCE MANUAL LINE
Instruction To refill the coolant the following steps are necessary. See also following figure.
Step
Procedure
1
Open the radiator cap (1) on the expansion tank (2). Visually check the rub-
ber seats inside the cap for condition and orientation.
2
Check the coolant level. The coolant level must be filled up to the top.
3
Inspect coolant with densimeter or glycol tester. Strongly discolored or
thickened coolant must be replaced.
NOTICE
Use only coolant as recommended in the current Operators Manual (OM) and SI-
916 i-001 “Selection of suitable operation fluids“, current issue.
Step
Procedure
4
If necessary, replenish with coolant of same composition.
5
Apply small amount of coolant to rubber surfaces inside cap (provides lubri-
cation to prevent binding). Tighten the radiator cap by hand.
NOTE
The radiator cap must be tightened until the stop lug is contacted.
Effectivity: 916 i A / C24
Edition 0/Rev. 1
12–10–00
Page 5
December 01 2023
To Next Page
Loading...
