BRP ROTAX 916 i A Series Maintenance Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
OIL CHANGE
Instruction
NOTE
Run engine to warm oil before beginning oil change procedure. To change the oil
the following steps are necessary:
Step
Procedure
1 Crank engine slowly by hand to transfer the oil from the crankcase.
See Chapter 12-10-00, section Oil level check/Replenish.
2
Remove safety wire and oil drain screw from the oil tank, drain the used oil.
3
Replace oil filter at each oil change, cut open and inspect the filter
components.
See Chapter 12-20-00 section Oil filter replacement and Inspection of the
filter insert.
4
Dispose of oil filter according to environmental regulations.
5
Install oil drain screw with new gasket and safety wire (tightening torque 25
Nm (18 ft. lb).
NOTICE
Only use brand name oil in accordance with the latest Operators Manual (OM)
and the latest Service Instruction “Selection of suitable operating fluids“ of the
respective engine type.
NOTICE
The engine must not be cranked when the oil system is open. Attention must also
be paid to this before first commissioning (e.g. when assembling the propeller
after correct purging of the oil system).
NOTICE
DO NOT use compressed air to blow through the oil system (or oil lines, oil cool-
er, oil pump housing, oil bores in the engine).
ENVIRONMENTAL NOTE
Protect the environment.
Do not harm the environment by spilling oil. Dispose of oil in an environmentally friendly
manner.
12–20–00
Page 30
December 01 2023
Effectivity: 916 i A / C24
Edition 0/Rev. 1

BRP ROTAX 916 i A Series Specifications

General

Brand	BRP
Model	ROTAX 916 i A Series
Category	Engine
Language	English