BRP ROTAX 916 i A Series Maintenance Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
Figure 5.18: TYPICAL
1 Coolant outlet elbow 2
Upper coolant hose
3 Clean container
Step
Procedure
2 Seal the open elbow side with a temporary piece of coolant hose, with a
plug inserted in the open end. The plug needs to hold a pressure of 2 bar
(29 psi).
NOTE
Use standard coolant water hose part no. 922250 and self com-
pensating clamp 25 part no. 851645 to secure. Plug diameter 12
-13 mm (0.473 in. - .0.512 in.).
05–50–00
Page 28
December 01 2023
Effectivity: 916 i A / C24
Edition 0/Rev. 1

BRP ROTAX 916 i A Series Specifications

General

Brand	BRP
Model	ROTAX 916 i A Series
Category	Engine
Language	English