BRP ROTAX 916 i A Series Maintenance Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
Step
Procedure
4
Remove the connection hose from expansion tank to overflow bottle and
install a temporary clear hose.
5
Refill the cooling system at the expansion tank and overflow bottle to
standard levels.
6 Apply small amount of coolant to rubber surfaces inside cap (provides lu-
brication to prevent binding). Tighten the radiator cap by hand.
NOTE
The radiator cap must be tightened until the stop lug is contacted
Figure 5.21
1 Overflow bottle 2
Temporary clear hose
Step
Procedure
7
Turn the propeller slowly by hand in the normal direction of rotation sev-
eral times. Check cooling liquid level again, if necessary replenish.
8
Pressurize the expansion tank up to relief pressure of the cap, indicated
by rising bubbles in the clear hose.
NOTICE
Do not relieve pressure via opening the radiator cap. Use pressure relief unit on
pump.
05–50–00
Page 30
December 01 2023
Effectivity: 916 i A / C24
Edition 0/Rev. 1

BRP ROTAX 916 i A Series Specifications

General

Brand	BRP
Model	ROTAX 916 i A Series
Category	Engine
Language	English