BRP ROTAX 916 i A Series Maintenance Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
NOTE
To make the entire cooling system check easier, the coolant may be entirely
drained, and the system pressurized with air only, up to 1.6 bar (23.2 psi.). Check
can be performed with leak detection fluid to locate the leakage.
After replacing any part of cooling system perform cooling system check again to make
sure the system works correctly.
Return coolant system to normal operating configuration.
Engine test run Engine test run is necessary:
Step
Procedure
1 Operate the engine until temperatures have stabilized for a period of 5
minute (engine oil temperature between 50 to 70 °C (122 to 160 °F).
2
Switch the engine “OFF”.
3 Allow the engine to cool down.
4
Check for leaks.
5
Check the coolant level and top up with coolant as required.
05–50–00
Page 32
December 01 2023
Effectivity: 916 i A / C24
Edition 0/Rev. 1

BRP ROTAX 916 i A Series Specifications

General

Brand	BRP
Model	ROTAX 916 i A Series
Category	Engine
Language	English