Need help?Do you have a question about the BRUSTOR B-128 and is the answer not in the manual?
General| Brand | BRUSTOR |
|---|---|
| Model | B-128 |
| Category | Accessories |
| Language | English |
Verify all parts and dimensions correspond to the order before installation.
Overview of different guide support types available for installation.
Remove covers, slide plates if needed, slide guides onto housing.
Place supports flush with guide back, 35cm from ends, spacing others evenly.
Slide guides onto fastening plates, fasten side guides, check squareness and parallelism.
Remove the cover of the front louvre before starting canvas tensioning.
Horizontally guide belt out, insert vertically along guide wheel, avoid over-rotation.
Join belt buckles to spring, evenly tighten sides until canvas is stretched.
Steps for adjusting the Orea RTS motor, including direction and end points.
Steps for adjusting and programming Sunea IO/Screen IO motors, end positions, and operation.
Place the support beam as a canvas support.
Secure end plates to a fastening plate in the guide using the specified bolt.
Slide and fasten the plastic end cap onto the support beam's end plate.
To Next Page
