EasyManua.ls Logo

Bryant 800SA User Manual

Bryant 800SA
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
800SA/801SA: Installation, Start–Up, Operating and Service and Maintenance Instructions
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
1
Installation, Start–Up, Operating and
Service and Maintenance Instructions
NOTE: Read the entire instruction manual before starting the
installation.
SAFETY CONSIDERATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
CODES AND STANDARDS . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
ELECTROSTATIC DISCHARGE (ESD) PRECAUTIONS PROCE-
DURE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
LOCATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
AIR FOR COMBUSTION AND VENTILATION . . . . . . . . . . . . 5
Table 1 – Minimum Free Area Required for Each Combustion Air
Opening or Duct to Outdoors. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Table 2 – Minimum Space Volumes for 100% Combustion, Ventila-
tion, and Dilution from Indoors . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
UPFLOW INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
DOWNFLOW INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . 8
Table 3 – Opening Dimensions - In. (mm) . . . . . . . . . . . . . . . . . . 9
HORIZONTAL INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . 9
LOCATION RELATIVE TO COOLING EQUIPMENT . . . . . . 10
AIR DUCTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
GENERAL REQUIREMENTS . . . . . . . . . . . . . . . . . . . . . . . . . . 11
SUPPLY AIR CONNECTIONS . . . . . . . . . . . . . . . . . . . . . . . . . 11
Table 4 – Air Delivery - CFM (With Filter)* . . . . . . . . . . . . . . . 12
Table 5 – Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
GAS PIPING. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Table 6 – Maximum Capacity of Pipe* . . . . . . . . . . . . . . . . . . . . 15
ELECTRICAL CONNECTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Table 7 – Electrical Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
J-BOX RELOCATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
ACCESSORIES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
NOTES FOR THERMOSTAT WIRING DIAGRAMS . . . . . . . 20
VENTING. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
GENERAL VENTING REQUIREMENTS . . . . . . . . . . . . . . . . 20
Table 8 – Combined Appliance Maximum Input Rating
in Thousands of Btuh per Hour . . . . . . . . . . . . . . . . . . . . . . . . . . 21
Table 9 – Minimum Allowable Input Rating of Space-Heating Appli-
ance in Thousands of Btuh per Hour . . . . . . . . . . . . . . . . . . . . . . 21
EXTERIOR MASONRY CHIMNEY FAN + NAT
INSTALLATIONS WITH TYPE-B DOUBLE-WALL
VENT CONNECTORS ©NFPA & AGA . . . . . . . . . . . . . . . . . . 22
VENTING NOTES FOR Fig. 31 - Fig. 43 . . . . . . . . . . . . . . . . . 25
START-UP, ADJUSTMENT, AND SAFETY CHECK . . . . . . . . . 25
GENERAL. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25
Table 10 – Altitude Derate Multiplier for U.S.A. . . . . . . . . . . . . 27
Table 11Orifice Size* and Manifold Pressure (In. W.C.) for Gas In-
put Rate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28
Table 12 – Orifice Size* And Manifold Pressure (In. W.C.) For Gas
Input Rate. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29
Table 13 – Gas Rate (Cu Ft./Hr.). . . . . . . . . . . . . . . . . . . . . . . . . 29
SERVICE AND MAINTENANCE PROCEDURES. . . . . . . . . . . . 30
GENERAL. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
ELECTRICAL CONTROLS AND WIRING . . . . . . . . . . . . . . . 31
CARE AND MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
CLEANING AND/OR REPLACING AIR FILTER. . . . . . . . . . 32
Table 14 – Filter Size Information (In. / mm) . . . . . . . . . . . . . . . 32
BLOWER MOTOR AND WHEEL. . . . . . . . . . . . . . . . . . . . . . . 32
CLEANING HEAT EXCHANGER . . . . . . . . . . . . . . . . . . . . . . 33
SEQUENCE OF OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34
WIRING DIAGRAM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36
TROUBLESHOOTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
PARTS REPLACEMENT INFORMATION GUIDE . . . . . . . . . . . 39
CASING GROUP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39
ELECTRICAL GROUP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39
BLOWER GROUP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39
GAS CONTROL GROUP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39
HEAT EXCHANGER GROUP. . . . . . . . . . . . . . . . . . . . . . . . . . 39
INDUCER GROUP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39
TRAINING. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39
Portions of the text and tables are reprinted from current edition of NFPA
54/ANSI Z223.1E, with permission of National Fire Protection Association,
Quincy, MA 02269 and American Gas Association, Washington DC 20001. This
reprinted material is not the complete and official position of the NFPA or ANSI
on the referenced subject, which is represented only by the standard in its entirety.
800SA/801SA
Single Stage, Multi-Speed ECM,
Non–Condensing Gas Furnace
Input Capacities: 45,000 Thru 155,000 Btuh
Use of the AHRI Certified TM Mark indicates a
manufacturer’s participation in the program. For
verification of certification for individual products,
go to www.ahridirectory.org.
D
E
S
I
G
N
C
E
R
T
I
F
I
E
D
Question and Answer IconNeed help?

Do you have a question about the Bryant 800SA and is the answer not in the manual?

Bryant 800SA Specifications

General IconGeneral
Model800SA
TypeGas Furnace
Efficiency RatingUp to 80% AFUE
StagesSingle-stage
Ignition TypeHot Surface Ignition
Heating Capacity40, 000 - 120, 000 BTU/h
Fuel TypeNatural Gas
Heat ExchangerAluminized Steel
Warranty10-year limited parts warranty

Summary

Safety Considerations

Fire, Explosion, Electrical Shock, and Carbon Monoxide Poisoning Hazard

Warnings about operation leading to injury, death, or property damage.

Introduction

Installation

Notes on furnace installation, including clearances to combustibles.

Electrostatic Discharge (ESD) Precautions Procedure

Location

Air for Combustion and Ventilation

Provisions for combustion, ventilation, and dilution air must be in accordance with NFGC and local codes.

Installation

Air Ducts

Gas Piping

Electrical Connections

115-V Wiring

Verify voltage, frequency, and phase match unit rating plate and utility supply.

Fire or Electrical Shock Hazard

Failure to follow warnings could result in dangerous operation, injury, death, or property damage.

Electrical Shock Hazard

Failure to follow warnings could result in personal injury or death.

Venting

General Venting Requirements

Follow safety codes for proper vent sizing and installation, including NFGC.

Venting

Carbon Monoxide Poisoning Hazard

Steps to follow for safe operation when connecting appliances to a venting system.

Exterior Masonry Chimney Fan + Nat Installations with Type-B Double-Wall Vent Connectors NFPA & AGA

Start-Up, Adjustment, and Safety Check

Fire Hazard

Warning about manual reset limit switches and combustion air supply.

Start-Up Procedures

Fire and Explosion Hazard

Warnings about testing for gas leaks and purging gas lines.

Adjustments

Fire Hazard

Warning against bottoming out gas valve regulator adjusting screw.

Check Safety Controls

Service and Maintenance Procedures

Fire, Injury, or Death Hazard

Warning about performing maintenance only if possessing required knowledge and skills.

Electrical Shock, Fire or Explosion Hazard

Electrical Controls and Wiring

Importance of maintaining electrical ground and polarity for proper operation.

Unit Damage Hazard

Electrical Shock Hazard

Warning about the blower access door switch controlling furnace control power.

Cleaning Heat Exchanger

Steps for cleaning heat exchangers due to dust or corrosion.

Fire or Explosion Hazard

Heating

Wiring Diagram

Troubleshooting

Related product manuals