Installation, Start--up, Operating and
Service and Maintenance Instructions
Series A
830SA
4- - WAY MULTIPOISE, ULTRA LOW NOX
80% AFUE GAS FURNACE
INPUT CAPACITIES 40,000 THRU 100,000 BTUH
SAFETY CONSIDERATIONS 2........................
INTRODUCTION 2..................................
CODES AND STANDARDS 4.......................
SAFETY 4......................................
GENERAL INSTALLATION 4......................
COMBUSTION AND VENTILATION AIR 4...........
DUCT SYSTEMS 4...............................
ACOUSTICAL LINING AND FIBROUS GLASS DUCT 4
GAS PIPING AND GAS PIPE PRESSURE TESTING 4...
ELECTRICAL CONNECTIONS 4...................
VENTING 4........................................
ELECTROSTATIC DISCHARGE
PRECAUTIONS PROCEDURE 4.......................
LOCATION 5.......................................
SAFETY CONSIDERATIONS 7........................
AIR FOR COMBUSTION AND VENTILATION 7..........
INSTALLATION 8...................................
UPFLOW INSTALLATION 8.......................
DOWNFLOW INSTALLATION 9....................
HORIZONTAL INSTALLATION 10..................
AIR DUCTS 11...................................
GAS PIPING 13..................................
ELECTRICAL CONNECTIONS 16..................
115--V WIRING 16................................
J-- BOX RELOCATION 16..........................
24--V WIRING 17.................................
ACCESSORIES 17................................
VENTING 19.......................................
MASONRY CHIMNEY REQUIREMENTS 19..........
APPLIANCE APPLICATION REQUIREMENTS 20.....
ADDITIONAL VENTING REQUIREMENTS 22........
SIDEWALL VENTING 22..........................
START-- UP, ADJUSTMENT, AND SAFETY CHECK 23.....
GENERAL 23....................................
START-- UP P ROCEDURES 24......................
ADJUSTMENTS 24...............................
AIR DELIVERY -- CFM 14.........................
CHECK SAFETY CONTROLS 26...................
CHECKLIST 26..................................
SERVICE AND MAINTENANCE PROCEDURES 29.......
ELECTRICAL CONTROLS AND WIRING 29.........
CARE AND MAINTENANCE 30....................
COMPONENT TEST 35...........................
CLEANING AND/OR REPLACING AIR FILTER 31.
BLOWER MOTOR AND WHEEL 31..............
FLAME SENSOR CLEANING AND SERVICING 32.
CLEANING HEAT EXCHANGER 32..............
SEQUENCE OF OPERATION 34....................
SERVICE GUIDE 36..............................
WIRING DIAGRAMS 35...........................
PARTS REPLACEMENT INFORMATION GUIDE 37....
Approved for installations up to 5,400 feet (1646 meters)
NOTE: Read the entire instruction manual before starting the
installation.
Portions of the text and tables are reprinted from current edition
of NFPA 54/ANSI Z223.1E, with permission of National Fire
Protection Association, Quincy, MA 02269 and American Gas
Association, Washington DC 20001. This reprinted material is
not the complete and official position of the NFPA or ANSI on
the referenced subject, which is represented only by the standard
in its entirety.
To Next Page
Need help?
General
