31
– Furnace
– Fan coil
– PAC AC Indoor
– PAC HP Indoor
– GAS PAC Indoor
– GAS PHP Indoor
• Outdoor:
– AC/Heat pump
• Geo HP
• PAC AC outdoor
• PAC HP outdoor
• GAS PAC outdoor
• GAS PHP outdoor
Once the equipment has been selected, the appropriate menus will be
displayed.
6.3.1. Thermostat
First touch SETUP, then touch THERMOSTAT to set up the parameters
for the Evolution Connex Control.
6.3.1.1. Auto Mode Set Up
Once the auto changeover option has been selected, touch SAVE.
• Enable or Disable: Choose to enable or disable auto changeover
mode. Default = Enable
• Simultaneous Heat/Cool: Choose to turn simultaneous heat cool
demand feature on or off. Default = Off
• If Simultaneous Heat/Cool is turned ON, Auto changeover time is
grayed out and shows N/A.
To Next Page