EasyManuals Logo

Bryant Legacy Touch-n-Go T2- PHP01- A User Manual

Bryant Legacy Touch-n-Go T2- PHP01- A
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
16
PROGRAMMING THE THERMOSTAT
Setting the home temperature
1. Open the door.
2. Press the home button located under the display on the
left. You will see a triangle icon (B) above the home but-
ton. This icon will always tell you whether you’re in the
home, away or sleep setting.
3. You will see the heating and cooling temperatures that
were set at the factory. To use these, just close the door.
4. To change the factory settings press the home button. You
will see the word heat flashing on the screen.
5. Press the up or down button until you reach the desired
temperature setting.
6. Press and hold the home button for about three seconds.
The set temperature will flash, indicating that it saved
your settings.
7. To change the cooling temperature setting, press the
mode button repeatedly until you see the word cool flash-
ingonthescreen.
8. Press the up or down button on the right side of the dis-
play until you reach the desired temperature setting.
9. Press and hold the home button for about three seconds. The set temperat-
ure will flash, indicating that it saved your settings.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bryant Legacy Touch-n-Go T2- PHP01- A and is the answer not in the manual?

Bryant Legacy Touch-n-Go T2- PHP01- A Specifications

General IconGeneral
BrandBryant
ModelLegacy Touch-n-Go T2- PHP01- A
CategoryThermostat
LanguageEnglish

Related product manuals