Need help?Do you have a question about the Brymen EEVblog BM235 and is the answer not in the manual?
General| Temperature Range | -40°C to 1000°C |
|---|---|
| Continuity Test | Yes |
| Diode Test | Yes |
| Auto Ranging | Yes |
| True RMS | Yes |
| Safety Rating | CAT III 1000V, CAT IV 600V |
| Battery Type | 2 x AA |
| Display | LCD |
| DC Current Range | 600μA to 10A |
| AC Current Range | 600μA to 10A |
| Frequency Range | 10Hz to 10MHz |
General safety advice for operating the meter safely, including avoiding moisture and using barriers.
Important cautions for safe operation and preventing damage, like disconnecting test leads.
Describes the different input jacks for current, voltage, and common connections.
Automatic voltage selection with low impedance for ghost voltage draining and accurate readings.
Using the SELECT button to cycle through ACV, DCV, and VFD-ACV functions for measurement.
How to perform resistance measurements using the SELECT button and interpret readings.
Using the continuity tester with audible and visible indicators for wiring and switches.
Performing diode tests and interpreting readings for good/defective diodes (forward/reverse bias).
How to select DC and AC current measurement modes using the SELECT button.
Capturing and viewing maximum, minimum, and average readings automatically.
Basic steps to resolve issues by checking battery, fuses, leads, and operating procedures.
Details on battery type, fuse types (F1, F2), ratings, and dimensions.
Step-by-step instructions for safely replacing the batteries and fuses.
Specifies accuracy for AC voltage measurements across various ranges and frequencies.
Accuracy and burden voltage specifications for DC current measurements.
Accuracy and burden voltage specifications for AC current measurements.
To Next Page
