26
Stereo Link
This parameter adjusts the stereo linking of various Input and
Output parameters and works in conjunction with the
Configuration setting. This parameter is also stored as part of
the Program data.
In 2 channel 3 way mode, Output pairs 1 and 2, 3 and 4, 5 and 6 are linked.
In LCR 2 way mode Outputs 1, 2 and 3 are typically low and 4, 5 and 6 are high.
Step and Offset
There are two different relationships between linked parameters; Step and Offset.
A Step parameter has discrete selections such as filter type, high pass slope, polarity, etc.
When channels are linked and a Step parameter is changed, e.g. high pass slope type, both
channel values will be forced to the same value.
Offset parameters dont have discrete selections, instead they have a range of numerical values
such as gain, frequency or delay. These parameters can have offsets between them when the
channels are linked. If any linked parameter reaches the value limit, none of the linked
parameters will be able to move further in that direction.
Table 1 Linked parameter relationships.
Utilities Stereo Link
@QbQ]UdUb <Y^[Y^WDi`U "3XQ^^U\#GQi <3B"GQi
9^`ed4U\Qi ?VVcUd 12 12
9^`ed5ADi`U CdU` 12 12
9^`ed5A6bUaeU^Si ?VVcUd 12 12
9^`ed5A ?VVcUd 12 12
?ed`ed>Q]U ?VVcUd !"#$%& !#$&
?ed`edC_ebSU ?VVcUd 1!#%2"$& 1!$2"&12#%
?ed`ed7QY^ ?VVcUd !"#$%& !#$&
?ed`ed<Y]Yd ?VVcUd !"#$%& !#$&
?ed`ed4U\Qi ?VVcUd !##%"$$& !$ "%#&
?ed`ed4U\Qi<Y^[ ?VVcUd !##%"$$& !$"%#&
?ed`ed@_\QbYdi CdU` !"#$%& !#$&
?ed`ed<_CXQ`U CdU` !"#$%& !#$&
?ed`ed<_6bUaeU^Si ?VVcUd !"#$%& !#$&
?ed`ed8YCXQ`U CdU` !"#$%& !#$&
?ed`ed8Y6bUaeU^Si ?VVcUd !"#$%& !#$&
?ed`ed5ADi`U CdU` !"#$%& !#$&
?ed`ed5A6bUaeU^Si ?VVcUd !"#$%& !#$&
?ed`ed5A ?VVcUd !"#$%& !#$&
?ed`ed5AGYTdX ?VVcUd !"#$%& !#$&
All manuals and user guides at all-guides.com
To Next Page
Loading...
