BSS Audio FDS-334T - Page 48

48
Q. I dont have any linked delays, but I cant get the maximum 635ms on an Input
or Output.
A. The maximum delay is a combination of the amount of delay assigned at the Input
section plus the amount assigned at the Output section. The maximum combined delay
from Input to Output is 635ms.
Q. What does Warning, no more filters mean?
A. Even with the flexibility and full feature set of the FDS-334T/336T, you could run
out of DSP resources at some stage, in some cases you might see the Warning, No More
Filters? message.
This indicates that there are no more filter sections available in one or both of the DSPs.
This can occur when trying to add more EQ, adding a crossover slope or increasing a
crossover slope. This message is most likely when using 48dB/Octave slopes that eat up
DSP resources quickly.
For more information about EQ/Filter assignments see the table in the DSP Filter/EQ
Assignment section.
Troubleshooting
www.audiovias.com
All manuals and user guides at all-guides.com