If you need some help, call us on 0800 145 6789* or go to bt.com/producthelp
Settings 62
If you wish to revert to not
using a PBX access code, you
need to go into the PBX code
menu and delete all the digits
by selecting Clear, then select
Save.
PBX access code
If you’re connected to a switchboard, you might
need to enter an access code (e.g.9) before each
number is dialled. Your BT6600 can store an access
code which is automatically dialled before each
number.
Set a PBX access code
1. Select Menu, scroll
to display Settings and
press Select.
2. Press
to highlight Base settings and press
Select.
3. Press
to display PBX Code and press Select.
4. Enter the number you want (maximum of 4 digits)
and select Save.
Change the system PIN
1. Select Menu, scroll
to display Settings and
press Select.
2. Press
to highlight Change Sys. PIN and
press Select.
3. If the current PIN is 0000, you will be prompted
to enter the new 4 digit PIN, then press OK. (Or, if
the current PIN is not 0000, you will be prompted
The default system PIN is 0000.
You can change this to your
own preferred 4-digit code.
The system PIN is different
to the call control PIN.
See page 33.
The system PIN is used when
changing certain settings and
for registration/de-registration.
If you make a mistake, select
Clear to delete a digit.
To Next Page
Loading...
