BT SG300 - Program Sequence; Programming flow chart; Factory Default Settings

9
4. Program Sequence
4.1 Programming flow chart
4.2 Factory Default Settings
The SG300BT sets with the factory default setting
when you start-up the SG300BT for the first time.
The factory default settings are shown with <> and
bold in the following sections. You can make your
own settings by following the procedures in this guide.
If you want to save the settings permanently, you
should scan the programming code of “Save
Parameters” otherwise the settings will not be saved
Start
Configuration
Recall
Parameters*
Set all
Default
Interface
Selection*
Communication
Parameters
Bar codes
Parameters
Misc.
Parameters*
etc.
Abort
Configurat
ion*
End
Configurat
ion
Save
Parameters