Controls and instruments truck with 360° steering
© BT 237077-040
31
Programming
When it’s possible to program the clock the character window for
hours will flash, pressing SELECT once to access the minutes
• Modify by stepping up one step using UP and down one step
using DOWN.
• Store the programmed value and displaying the next address
by pressing SELECT.
When error codes are shown in character window (C) the char-
acter box (G) will be lit and when the parameters are displayed
in character window (C) the character box (F) will be lit. How
-
ever, it is not possible to reprogram these parameters from here.
If this is necessary please contact a trained service technician.
Quit programming by switching the ignition key off and on once.
Programming is also stopped if no button is pressed within
twenty seconds.
NOTE.
Truck handling.
The handling characteristics of the truck will change if you
change any of the truck specific parameters. Do not change
any parameters without possessing the necessary know-how.
Function Value
Hours 09 = 9h
Minutes 35 = 35 min.
To Next Page
Loading...