Maintenance
© BT 237077-040
69
• Bear in mind that the oil in the transmission or the hydraulic
system can be hot.
WARNING!
Chemical reaction.
Prolonged skin contact with hydraulic oil can lead to skin irri-
tation.
Avoid prolonged skin contact with hydraulic oil.
WARNING!
Risk of burns.
Hot transmission and hydraulic oil.
Let the truck cool before replacing the oil.
• Only fill the hydraulic system with new and clean oil.
WARNING!
The hydraulic system can be damaged.
If the oil is contaminated hydraulic components can be dam-
aged.
Always use new and clean oil in the hydraulic system.
• Store and dispose of changed oil in accordance with local
directives.
• Do not release solvents and the like, which are used for
cleaning/washing, into drains that are not intended for this
purpose. Follow the local directives that apply for disposal.
• Disconnect the battery when welding on the truck.
NOTE!
The battery can be damaged.
When welding using an electric power source the welding cur-
rent can enter the battery.
The battery should therefore be disconnected.
• Remove at least 100 mm (4”) of paint around the welding/
grinding area through sand-blasting or the use of a paint strip
-
per when welding or grinding on painted surfaces.
CAUTION!
Harmful gases.
Paint that is heated gives off harmful gases.
Remove 100 mm (4”) of paint from the work area.
• When working underneath the truck, support the truck on
trestle-blocks.
WARNING!
Risk of crushing.
A badly supported truck can fall.
Never work under a truck that is not supported on trestle-
blocks and secured by a lifting device.
To Next Page
Loading...