BT Vision+ - TV Remote Control Integration; Setting Up and Using the Remote

Controlling your TV with your remote
You can operate your TV using your BT remote. Use it to turn the TV
on and off (standby), change channel, adjust the volume and mute
the sound.
How to set your BT remote to control your TV
Before you start, make sure the volume on your BT Vision+ box isn’t
muted or set too low. Your remote will only control your TV volume once
it’s programmed, so you need to do this now. If you need to change it
later, you’ll need to reset your remote (see box below).
1
Find your TV’s four-digit unique code. Some common codes are
in the table on the right.
2
Press and hold Vol and on your BT remote until its blue
light flashes three times.
3
Type in your TV’s four-digit code.
4 Your remote’s blue light should flash three times. If the code’s
wrong, the blue light will flash for one second after you type the
code’s last digit – try again.
5
Once you’ve entered the code, test the remote by turning the
volume up and down and pressing . If the buttons don’t work
properly, repeat the steps above using another code.
6
To test your remote some more, press and hold while trying
Channel or . This should change the channel on your TV
rather than BT TV.
7
If the TV doesn’t react, start again from Step 1 with the next code.
TV Code 1 Code 2 Code 3
Goodmans 0000 0011 0016
Hitachi 0018 0020 0000
JVC 0016 0058 0011
LG 0017 0000 0019
Panasonic 0005 0000 0110
Philips 0000 0033 0001
Samsung 0002 0003 0000
Sharp 0014 0016 0102
Sony 0001 0084 0126
Toshiba 0077 0043 0056
Can’t find your code? Go to bt.com/vision/remotecontrol
Need to reset your remote?
Press , and at the same time for 5 seconds. When the
light on your remote flashes 3 times, your remote will be reset
and you’ll be able to use it to change the volume of your
BT Vision+ box.
How to use BT TV
20