5.4 Assembling of the bead producing unit
The bead producing unit is the central part of the Encapsulator B-390. It is fully autoclavable.
Figure 5-3 shows the different parts of the bead producing unit. The assembled bead producing unit
is attached with the screw on the carrier plate of the control unit. The vibration unit is placed on the
magnet holder without the need of further attachment.
a Magnet holder *
Membrane
Magnet
Flat gasket (14×1.78)
Pulsation chamber
Pre-filter with 50 µm mesh
O-ring (3.68x1.78)
Luer Lock
Screw M3×8
Screw M3×25
k Screw M3×6
*with attached fixation ring and
screws M3×5.
You can remove the fixation
ring for cleaning.
Figure 5-3: Parts of the bead producing unit
5.5 Single (inner) nozzles
A high quality nozzle is crucial for homogenous bead production. The holes of the Encapsulator
nozzles are precisely drilled using the newest technology. Every Encapsulator B-390 is delivered with
a set of 8 nozzles; nozzle aperture sizes are 80, 120, 150, 200, 300, 450, 750 µm and 1.0 mm. They
are made completely of stainless steel.
Figure 5-4: Set of 8 nozzles on the nozzle rack
The nozzle rack contains 8 nozzles (80, 120, 150, 200, 300, 450, 750 µm, and 1.0 mm). The size of
the O-ring is 4.47×1.78.
To Next Page
Loading...
