Comment
This specifies an arbitrary comment text of up to 129 characters. The memo field
is saved in the file header and is displayed when opening the data from the disk
using the Trace Information button from the File dialog.
Scan Now
The Scan Now button causes the instrument to begin collecting a sample
spectrum. This command uses the scan range and comment information options
that have been previously entered into the appropriate text boxes.
Scan Type
Scan Type determines the instrument mode for data collection. The instrument can
be set to Ratio, Reference or Single Beam mode. However, all spectral data set to
the computer will be single beam data.
Pen Response
Pen Response determines the instrument pen response during data collection.
Gain
Gain determines the instrument gain setting during data collection.
5.0 Communications
When the software is installed a file called “BUCK500.INI” is created when you first run the
BUCK 500 Instrument control software. It is stored in the same directory to which the
instrument control software has been installed. This file contains RS232 communications
information as well as some instrument SETUP parameters. If an incorrect port number has
been entered during the initial software setup, this file may have to be edited using Notepad
application (or any text editor) to set the correct PORT number.
To Next Page
Loading...
