Need help?Do you have a question about the Buell 2008 XB SERIES and is the answer not in the manual?
General| Fuel System | Electronic Fuel Injection |
|---|---|
| Transmission | 5-speed |
| Final Drive | Belt |
| Compression Ratio | 10.0:1 |
| Horsepower | 103 hp |
| Front Suspension | Showa inverted fork |
| Rear Suspension | Showa shock absorber |
| Front Brakes | Single disc |
| Rear Brakes | Single disc |
| Wheelbase | 52 in. (1321 mm) |
| Seat Height | 30.5 in |
| Displacement | 984 cc |
| Torque | 84 ft-lb |
Describes the manual's intent to acquaint users with Buell products and diagnostic methods.
Guides users on navigating the manual using tables, index, and cross-references.
Emphasizes the importance of a clean work area and gathering necessary tools before starting repairs.
Contains detailed specifications for the starter and service wear limits.
Provides diagnostic procedures and tool names for identifying starting system issues.
Lists probable causes and solutions for starter malfunctions like not running or running at low speeds.
Covers the components of the charging system, including the alternator and regulator, and troubleshooting.
Details procedures for battery testing using voltmeter, conductance test, and load test.
Provides specifications for fuel system, idle speed, battery, spark plugs, alternator, regulator, electrical system, and ignition coils.
Explains how to observe the check engine lamp's behavior to identify fault conditions and trouble codes.
Guides users through a systematic approach to identifying system problems by comparing engine behavior to tables.
Offers diagnostic flowcharts for troubleshooting when the engine cranks but does not start.
Describes the procedure for testing fuel pressure and identifying potential issues.
Provides diagnostic steps for identifying and resolving engine misfires at idle or under load.
Details procedures for separating, mating, and removing/installing AMP Multilock connector terminals.
Explains how to repair Deutsch electrical connectors, including separating and mating housings.
Details the process of preparing wire leads and crimping Metri-Pack terminals.
Covers preparing wire leads, splicing wire leads, and inspecting seals for sealed splice connectors.
Lists connector locations for various components on Buell motorcycles.
Provides information on wire color codes, wiring diagram symbols, and lists available wiring diagrams.
Presents conversion tables for inches to millimeters and vice versa.
Offers equations for converting torque values between United States and metric systems.
Lists acronyms and abbreviations used in the manual with their descriptions.
To Next Page
