Buffalo GH187 - Electrical Connection; Water Connection

MAINS CABLE
MAINS WATER
CONNECTION
FILTER HEAD
(FILTERED MODEL(S) ONLY)
STEAM VENT
MAINS CABLE
MAINS WATER
CONNECTION
STEAM VENT
FILTERED UNFILTERED
Electrical Connection:
The appliance must be earthed.
Check that the voltage on the rating plate of your appliance corresponds with your
electricity supply.
The boiler is supplied with a 13 amp plug. If replacing the plug, connect the terminals
as follows:
GREEN and YELLOW wire EARTH - E
BLUE wire NEUTRAL - N
BROWN wire LIVE - L
For safety regulations the plug or means of disconnection must always be accessible.
Water Connection:
Connect the supplied inlet hose to the inlet connection point on the base of the appli-
ance and the other end to the mains cold water supply.
Overow & Drainage
Duetotheelectronicfunctionoftheapplianceitishighlyunlikelythatanoverow
wouldoccur.Theapplianceisdesignedsothatanyoverowoccurrenceandconden-
sation is directly vented into the drip tray.
Note: There will be some steam emissions from the vent at the base of the appli-
anceduringitsinitialllstages.Thesteamemissionswilllessenasthewatervolume
increases in the tank.
GC719
GH187