EasyManua.ls Logo

Buffalo GM949 - Page 8

Buffalo GM949
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
EN
8. The preheating screen flashes
a second, then switch to
rinsing screen.
9. After the intial preheating and rinsing, the home page will be shown. The appliance is now ready for
normal use.
Café Au Lait
Long Coffee Hot Water
Hot Milk Foam
AmericanoEspresso
Cappuccino Coffee Latte
Caution
When using for the first time, the appliance may emit louder noise than normal
as the water supply pipeline is empty. When the pipeline is refilled, the noise
will drop. The noise level will reduce to normal after making 3 to 4 cups of
coffee.
Danger of
scalds
Each time the appliance is switched on, it will automatically run preheating and
rinsing. This process cannot be interrupted and the machine can only be used
after finishing the cycle.
During preheating and rinsing, hot water will come from the outlets then flow
into the waste water tank. Take caution of the splashing hot water.
10. Turning off:
Press button for 3 seconds.
The machine will run the system rinsing to clean the pipeline. (Tip: If
coffee with milk has been made, the machine will remind you to clean
the milk foam system. For details, refer to the section “Milk foam system
cleaning”.)
After system cleaning done, the control panel turns off.
Set the power switch to “O” position. If the machine is not to be used
for an extended period, disconnect it from the power supply.
Caution
To avoid damage, DO NOT turn off the power switch before the system cleaning
is completed or while the appliance is running.
GM949_EN_A5_v1_20240528.indb 8GM949_EN_A5_v1_20240528.indb 8 2024/5/28 11:272024/5/28 11:27