3.
4.
Check both sides of the dipstick, and read the lower
level. The fluid level must be in the cross-hatched
area.
If the fluid level is where it should be, push the
dipstick back in all the way.
How
to
Add
Fluid:
Refer
to
the Maintenance Schedule to determine what
kind
of
transaxle fluid to use. See “Recommended
Fluids and Lubricants” in the Index.
If the fluid level
is
low, add
only
enough
of
the proper
fluid to bring the level into the cross-hatched area on the
dipstick. It doesn’t take much fluid, generally less than a
pint. Don’t overfill. We recommend you use only fluid
labeled DEXRONa-IIE, because fluids with that label
are made especially for your automatic transaxle.
Damage caused by fluid other than DEXRONs-IIE
is
not covered by your new vehicle warranty.
0
After adding fluid, recheck the fluid level as
described under “How to Check.”
0
When the correct fluid level
is
obtained, push the
dipstick back in all the way.
Engine
Coolant
The following explains your cooling system and how
to
add coolant when
it
is low. If you have a problem with
engine overheating, see “Engine Overheating” in the
Index.
The proper coolant for your Buick will:
0
Give freezing protection down
to
-34OF
(-37OC)
.
0
Give boiling protection up to 262°F (128 “C)
.
0
Protect against rust and corrosion.
0
Help keep the proper engine temperature.
Let the warning lights work as they should.
What
to
Use:
Use a mixture
of
one-half clean water (preferably
distilled) and one-half antifreeze that meets
“GM
Specification 1825-M,” which won’t damage aluminum
243
To Next Page
Loading...
