Driving and Operating 9-43
If d comes on and stays on, reset
the system. To reset:
1. Stop the vehicle.
2. Turn the engine off and wait
15 seconds.
3. Start the engine.
If
d still comes on and stays on, the
vehicle needs service.
With Interactive Drive Control
System
Without Interactive Drive Control
System
.
To turn off both StabiliTrak
and TCS, press and hold the
TCS/StabiliTrak button, located
on the instrument panel,
until
i and g illuminate and the
appropriate DIC message is
displayed. See Ride Control
System Messages on page 5‑33.
When StabiliTrak is turned off,
the system will not assist with
directional control of the vehicle
or limit wheel spin. Driving
should be adjusted accordingly.
See StabiliTrak
®
OFF Light on
page 5‑21 for more information.
.
Press and release the
TCS/StabiliTrak button again
to turn the system back on.
If cruise control is being used when
StabiliTrak activates, cruise control
will automatically disengage.
Press the cruise control button to
reengage when road conditions
allow. See Cruise Control on
page 9‑45 for more information.
To Next Page
Loading...
