Vehicle Care 10-37
To replace any one of these bulbs:
1. Open the trunk. See Trunk
Release on page 1‑5.
2. Remove the taillamp assembly
access panel.
3. Remove the two nuts that
secure the taillamp assembly.
4. Remove the taillamp assembly
and detach the wiring harness
connector.
A. Back-up Lamp
B. Taillamp
C. Stop/Turn Signal Lamp
D. Taillamp/Sidemarker Lamp
5. Turn the bulb socket
counterclockwise to remove it.
6. Pull the bulb from the socket.
7. Install a new bulb.
8. Turn the bulb socket clockwise
to install it.
9. Reverse Steps 2 through 4 to
reinstall the taillamp assembly.
License Plate Lamp
To replace one of these bulbs:
Passenger Side Shown,
Driver Side Similar
1. Push the release tab (A) toward
the lamp assembly.
2. Pull the lamp assembly down to
remove.
To Next Page
Loading...
