Buick 2012 Regal - Replacement Bulbs; Electrical System; High Voltage Devices and Wiring

Black plate (38,1)
Buick Regal Owner Manual - 2012
10-38 Vehicle Care
A. Bulb Socket
B. Bulb
C. Lamp Assembly
3. Turn the bulb socket (A)
counterclockwise to remove it
from the lamp assembly (C).
4. Pull the bulb (B) straight out of
the bulb socket.
5. Push the replacement bulb
straight into the bulb socket and
turn the bulb socket clockwise to
install it into the lamp assembly.
6. Push the lamp assembly back
into position until the release tab
locks into place.
Replacement Bulbs
Exterior Lamp
Bulb
Number
Back-up Lamp 3157 K
Fog Lamp H10
Front Turn
Signal Lamp
3457 NAK
Front Sidemarker
Lamp (Base)
194NA
High‐Beam
Headlamp (Base)
H7
License Plate Lamp 194
Low‐Beam
Headlamp/Daytime
Running
Lamp (DRL)
H11
Stoplamp/Turn
Signal Lamp
3157 K
Taillamp/
Sidemarker Lamp
3157 K
For replacement bulbs not listed
here, contact your dealer.
Electrical System
High Voltage Devices and
Wiring
{
WARNING
Exposure to high voltage can
cause shock, burns, and even
death. The high voltage
components in the vehicle can
only be serviced by technicians
with special training.
High voltage components are
identified by labels. Do not
remove, open, take apart,
or modify these components.
High voltage cable or wiring has
orange covering. Do not probe,
tamper with, cut, or modify high
voltage cable or wiring.