Heated Windshield Washer
For vehicles with the heated
windshield washer fluid system, it
can be used to help clear ice, snow,
tree sap, or bugs from the
windshield. This feature only works
with the front wiper system.
The button is located to the left
of the steering column below
the instrument panel brightness
control knob.
Press the heated washer fluid
button to activate the heated
windshield washer fluid system. This
activation begins four heated
wash/wipe cycles. The first heated
wash/wipe cycle can take up to
40 seconds to occur, depending on
outside temperature. After the
first wash/wipe cycle, it can take up
to 20 seconds for each of the
remaining cycles. The system turns
off automatically after four wipe
cycles or the button can be pressed
again to turn it off.
Under certain outside temperature
conditions, steam might flow
out of the washer nozzles for a
short period of time before washer
fluid is sprayed. This is normal.
HEATING WASH FLUID WASH
WIPES PENDING is displayed on
the DIC when the washer system is
heating the fluid.
WASHER FLUID LOW ADD FLUID
is displayed when the washer
fluid is low. See DIC Warnings and
Messages on page 3-48.
Rear Window
Wiper/Washer
The rear wiper and rear wash
button is located on the instrument
panel below the climate control
system.
Z (Rear Wiper): Press to turn the
rear wiper on and off. The wiper
speed cannot be changed.
Y (Wash): Press to spray washer
fluid on the rear window. The
window wiper will also come on.
Release the button when enough
fluid has been sprayed on the
window. The rear wiper will run a
few more cycles after it is released.
If the rear wiper function was
already on, prior to pressing the
wash button, it stays on until
the wiper button is pressed again.
The rear window washer uses
the same fluid that is in the
windshield washer reservoir. See
Windshield Washer Fluid on
page 5-23.
Instrument Panel 3-9
To Next Page
Loading...
Need help?
General
