Using Cruise Control on Hills
How well the cruise control will work
on hills depends upon the vehicle
speed, load, and the steepness
of the hills. When going up steep
hills, you might have to step on the
accelerator pedal to maintain the
vehicle speed. When going downhill,
you might have to brake or shift
to a lower gear to keep the vehicle
speed down. When the brakes
are applied the cruise control
is disengaged.
Ending Cruise Control
There are three ways to end cruise
control:
• Step lightly on the brake pedal.
• Press the [ button.
• Press the T button.
Erasing Speed Memory
The cruise control set speed memory
is erased when the cruise control or
the ignition is turned off.
Exterior Lamps
The exterior lamps control is located
on the instrument panel to the left
of the steering wheel.
It controls the following systems:
• Headlamps
• Taillamps
• Parking Lamps
• License Plate Lamps
• Instrument Panel Lights
• Fog Lamps
The exterior lamps control has
four positions:
9 (Off): Briefly turn to this
position to turn the automatic light
control off or on again.
AUTO (Automatic): Turns the
headlamps on automatically
at normal brightness, together with
the following:
• Parking Lamps
• Taillamps
• License Plate Lamps
• Instrument Panel Lights
; (Parking Lamps): Turns the
parking lamps on together with the
following:
• Taillamps
• License Plate Lamps
• Instrument Panel Lights
3-12 Instrument Panel
To Next Page
Loading...
Need help?
General
