Instruments and Controls 5-9
3. Press the set/reset button to
start the compass calibration.
4. The DIC will display
CALIBRATING: DRIVE IN
CIRCLES. Drive the vehicle
in tight circles at less than
8 km/h (5 mph) to complete the
calibration. The DIC will display
CALIBRATION COMPLETE
for a few seconds when the
calibration is complete. The DIC
display will then return to the
previous menu.
Clock
To adjust the time and date:
1. Turn the ignition key to
ACC/ACCESSORY or ON/RUN,
then press
O to turn the
radio on.
2. Press
G to display HR, MIN,
MM, DD, YYYY (hour, minute,
month, day, and year).
3. Press the pushbutton located
under any one of the labels
to be changed.
4. To increase the time or date,
do one of the following:
.
Press the pushbutton below
the selected label.
.
Press ¨ SEEK.
.
Press \ FWD.
.
Turn f clockwise.
5. To decrease the time or date,
do one of the following:
.
Press © SEEK.
.
Press s REV.
.
Turn f counterclockwise.
To change the time default setting
from 12 hour to 24 hour or to
change the date default setting from
month/day/year to day/month/year:
1. Press
G and then the
pushbutton located under the
forward arrow that displays on
the radio screen until the time
12H (hour) and 24H (hour), and
the date MM/DD (month and
day) and DD/MM (day and
month) display.
2. Press the pushbutton located
under the desired option.
3. Press
G again to apply the
selected default, or let the
screen time out.
To Next Page
Loading...
Need help?
General
