Buick Enclave User Manual

Black plate (30,1)
Buick Enclave Owner Manual - 2012
10-30 Vehicle Care
3. Remove the two hex nuts
holding the taillamp assembly
in place.
4. Pull out the taillamp assembly.
5. Turn the bulb socket
counterclockwise and pull it
straight out to remove it.
6. Replace the bulb.
7. Reverse Steps 3 through 5 to
reinstall the taillamp assembly.
When reinstalling the taillamp
assembly, the pin on the taillamp
assembly must line up and
be inserted correctly into the
opening.
8. Replace the black cuff over the
lamp assembly by pushing it into
the snap tabs.
License Plate Lamp
To replace one of these bulbs:
1. Remove the two screws holding
each of the license plate lamps
to the liftgate trim.
2. Turn and pull the license plate
lamp forward through the liftgate
trim opening.
3. Turn the bulb socket
counterclockwise and pull the
bulb straight out of the socket.
4. Install the new bulb.
5. Reverse Steps 1 through 3 to
reinstall the license plate lamp.
Replacement Bulbs
Exterior Lamp
Bulb
Number
License Plate Lamp 194LL
Rear
Sidemarker Lamp
194LL
Rear Turn Signal
and Taillamps
7443
(W21/5W)
For replacement bulbs not listed
here, contact your dealer.
Information Provided by:

Buick Enclave Specifications

General

Brand	Buick
Model	Enclave
Category	Automobile
Language	English