3-10 Seats and Restraints
Raising the Seatback
{
WARNING
If either seatback is not locked, it
could move forward in a sudden
stop or crash. That could cause
injury to the person sitting there.
Always push and pull on the
seatbacks to be sure they are
locked.
{
WARNING
A safety belt that is improperly
routed, not properly attached,
or twisted will not provide the
protection needed in a crash.
The person wearing the belt could
be seriously injured. After raising
the rear seatback, always check
to be sure that the safety belts
are properly routed and attached,
and are not twisted.
To raise a seatback:
1. Lift the seatback up and push it
rearward to lock it in place.
Make sure the safety belt is in
the retainer clip and is not
twisted or caught in the
seatback.
A tab near the seatback lever
retracts when the seatback is
locked in place.
2. Push and pull the top of the
seatback to be sure it is locked
into position.
3. Repeat Steps 1 and 2 for the
other seatback, if necessary.
When the seat is not in use,
it should be kept in the upright,
locked position.
Rear Seat
Pass-Through Door
The vehicle may have a door in the
rear seat that provides access to the
trunk.
Lower the rear seat armrest to
access the pass-through door. Pull
the release handle to open the door.
To close, push and latch the door.
The vehicle may have a lock knob
on the pass-through door. Turn the
lock knob from the trunk side of the
door to lock or unlock the door.
To Next Page
Loading...
