What does dSd mean on Built Right Swimming Pool Heater?
If the control display on your Built Right Swimming Pool Heater is flashing "dSd", it indicates a defrost sensor malfunction or that the sensor is not connected. It is recommended to call for service.
What does LP3 mean on Built Right BR115 S7 Swimming Pool Heater?
If your Built Right Swimming Pool Heater control display is flashing "LP” or "LP3”, it indicates low refrigerant or a faulty low-pressure sensor. It is recommended to call for service.
What does FS5 mean on Built Right BR115 S7?
If the control on your Built Right Swimming Pool Heater displays “FS5”, it indicates that the air temperature is still too cold after five “FS” signals. Once the air temperature rises above 50°F, press any key on the control to resume normal operation. If no key is pressed, the heater will enter a one-hour standby mode. If it remains too cold after the standby mode, the 15-minute FS cycles will resume.
Why is my Built Right Swimming Pool Heater flashing FS?
If your Built Right Swimming Pool Heater control display is flashing “FS” or “FS1, FS2, FS3, FS4”, it means the air temperature is too cold for the heater to operate. Wait until the air temperature warms up to at least 50°F (10°C). The heater will automatically cycle on for 2 minutes every 15 minutes to check if the temperature is warm enough to resume normal operation.
Why is water leaking from my Built Right Swimming Pool Heater?
If water is running out of the bottom of your Built Right Swimming Pool Heater, it could be due to condensation or an internal leak. The heater can produce up to 3 gallons per hour of water condensing from the evaporator coil. First, shut the heater off for several hours but leave the pool pump running. If water continues to leak, call for service.
What to do if Built Right BR115 S7 displays FLO?
If the control display on your Built Right Swimming Pool Heater is flashing “FLO”, it means there's an issue with water flow. First, ensure the pool pump is turned on. Then, check that the skimmer basket, pump strainer basket, and pool filter are all clean. Finally, make sure the valves are set properly to allow adequate water flow.
How to fix HP error on Built Right BR115 S7?
If your Built Right Swimming Pool Heater control displays “HP, HP3, or HP6”, it indicates a water flow restriction. To resolve this, clean the pump and filter. Also, adjust the water valves to ensure proper flow. If the problem continues, it is recommended to call for service.
Guidance on optimal placement to avoid water damage and ensure visibility.
Minimum spacing requirements for air circulation and access.
Instructions for installing the unit on a stable, pitched surface for drainage.
Recommendations for securing the unit against movement or wind.
Requirement to connect all metallic components to a common bonding grid for safety.
How to switch between pool and spa temperature settings.
Information on how the temperature is displayed and how to change units.
Instructions for locking and unlocking the control panel keypad.
Guide to adjusting the desired pool or spa water temperature.
Guidance on setting pool pump runtime for effective heating.
Steps to follow before the first time starting the heater.
Explanation of the defrost cycle and its indicator.
How normal condensation drainage works and where it comes from.
Instructions for connecting and using an external controller.
Instructions for cleaning the evaporator coil and unit housing.
Procedures for preparing the unit for freezing conditions.
General| Brand | Built Right |
|---|---|
| Model | BR115 S7 |
| Category | Swimming Pool Heater |
| Language | English |
To Next Page
