To Next PageTo Next Page
Need help?Do you have a question about the Bunn A10 and is the answer not in the manual?
General| Voltage | 120V |
|---|---|
| Water Reservoir | Removable |
| Power | Electric |
| Watts | 900W |
| Tank Type | Removable water reservoir |
Details electrical, dimensional, capacity, and weight specifications for the coffee brewer.
Important safety and operational notices regarding the brewer and its labels.
Identifies and illustrates key switches like Start, Warmer, Vacation, and Batch Size.
Safety and installation requirements for compliance with CE standards.
Details water supply pressure, tubing, and hook-up instructions for the A10 model.
Instructions for pouring water into the A10/A10A models to start brewing.
Instructions for starting brewing on automatic models using the start switch.
Steps for removing the brew funnel and grounds after brewing stops.
Procedure to increase or decrease batch brew time using the START switch.
Procedure to set desired batch brew volumes using START and ON/OFF switches.
Instructions for periodically tightening the screw in the handle using a screwdriver.
Steps for removing mineral deposits from the sprayhead using a deliming spring probe.
Guidance on using special sprayheads for softened water or decaf coffee.
Recommendation to install a water conditioner for water with sediment, taste, or odors.
Describes extra glass decanters for serving beverages like coffee, tea, and hot chocolate.
Highlights Bunn paper filters for consistent brewing without grounds.
