To Next Page

To Previous Page

PREPARING THE BREWER FOR USE

NOTE: THE BREWER IS NOT READY TO PLUG IN

Raisethehingediplid.

Place the decanter on the warmer. Pour two pitchers of water

(ﬁlled to the top line) into the screened area on top of the brewer.

Wait two minutes between pitchers to allow the water to ﬁll the

tank.Whenthetankisfull,somewaterwillowthroughthe

funnel and into the decanter.

Close the lid and plug in the brewer.

Press the top of the vacation switch, located on the

lower left side of the brewer, to the “ON” (I) position.

The vacation switch controls power to the tank heater.

Initially you will have to wait approximately ten minutes

in order for water to reach brew temperature.

P2078

P2079

P-214

P2080.15

ALL MODELS

43422.1 010311

Bunn A10 User Manual

Other manuals for Bunn A10