Bunn H5X User Manual

INSTALLATION & OPERATING GUIDE
BUNN-O-MATIC CORPORATION OF CANADA
280 INDUSTRIAL PARKWAY SOUTH,
AURORA, ONTARIO, L4G 3T9
PHONE: (905) 841-2866 FAX: (905) 841-2775
To ensure you have the latest revision of the manual or to obtain the illustrated parts catalog, please visit
the Bunn-O-Matic website, at www.bunn.com. This is absolutely FREE, and the quickest way to obtain
the latest catalog and manual updates. Contact Bunn-O-Matic Corporation at 1-800-263-2256 to obtain
a paper copy of the required Illustrated Parts Catalog mailed via Canada Post.
46819.7000A 06/12 © 2012 BUNN-O-MATIC CORPORATION
Hot Water
Dispensers
Supercedes
10052.7000; 10010.7000; 10267.0000
10420.7000; 10889.7000; 39338.7000
39338.7001; 44306.7000

Bunn H5X Specifications

General

Model	H5X
Category	Water Dispenser
Capacity	5 gallons
Heating Element	Stainless Steel
Brand	Bunn
Material	Stainless Steel
Power	120V, 60Hz
Electrical	120V, 60Hz

Summary

Commercial Product Warranty

Introduction to the Dispenser

User Notices and Warnings

Product Labels and Decals

Identification labels and warning decals for the dispenser.

Electrical Requirements and Connections

Electrical Wiring Diagrams

Diagrams for 120V, 230V, and 208/240V AC models.

CE Safety Requirements

Safety and installation guidelines for CE compliance.

Plumbing and Initial Setup

Water Supply Connection Requirements

Requirements for connecting the cold water supply.

Initial Setup Procedures

Steps for initial setup of specific dispenser models.

Model-Specific Initial Setup

Setup instructions for H5M, HW2, and OHW models.

Normal Use Guidelines

How to operate the dispenser during normal use.

Operating Controls and Dispense Volume Adjustment

Control Panel Overview

Description of dispenser control panel buttons and indicators.

Adjusting Dispense Volumes

Procedure for setting water dispense volumes.

Programming for H5-E, H5-PC, H5X, H10X Models

Model Identification and Level 1 Programming

Identifying models and setting initial program levels.

Level 2 Programming for H5-E/PC/X/10X Models

Advanced programming options including lockout and temp selection.

Programming for H5-Element Models

Temperature Adjustment

How to adjust the water temperature setting.

Manual Energy Saver Mode

Activating and deactivating the energy saving mode.

Program Lockout Switch

Setting up or disabling programming access.

Level 2 Programming for H5-Element Models

Advanced programming options including temp units and defaults.

Installation, Draining, and Cleaning

Dispenser Draining Procedures

Instructions for draining the dispenser tank.

Dispenser Cleaning

Recommended method for cleaning dispenser surfaces.

Wall Mounted Installation

Guidelines for wall mounting 5-gallon dispenser models.

Support for Large Receptacles

Recommendations for using large containers with the dispenser.