Bunn IC3 - USER NOTICES; ELECTRICAL REQUIREMENTS

Page 2
These brewers require either 3-wire, grounded service rated 120/208 or 120/240 volts ac or 2-wire, grounded
service rated 200 volts ac, or 20 amp, single phase, 60 Hz. Refer to the product’s data plate above the dilution
nozzle for actual voltage of your particular brewer model.
NEUTRAL
WHITE
L1 BLACK
208 or 240V.A.C.
120V.A.C.
120V.A.C.
L2 RED
USER NOTICES
The notices on this brewer should be kept in good condition. Replace unreadable or damaged labels.
00831.0000
03409.0000
03408.0000
200V.A.C.
L1 BLACK
L2 RED
ELECTRICAL REQUIREMENTS
CAUTION - Do not connect the brewer to the power source until specified in Initial Set-Up.
10792 021594