Bunn ICB SH - Initial Disassembly Steps; Faucet and Component Removal

• Disconnect power to the brewer.
• Remove the screws that secure the front
panel to the brewer (6 screws).
STEP 1
• Carefully remove the front panel of the
brewer.
STEP 2
ICB SH Faucet Side Car Installation Instructions
• Remove the three screws that secure the
cover to the faucet side car.
• Remove the cover.
STEP 3
• Open the faucet handle to drain water from
the tank. Keep the faucet handle open until
water is no longer dispensing.
• Remove the hose snap clamp that secures
the tube to the faucet shank.
• Carefully remove the hose from the faucet
shank.
STEP 4
• Remove the two 8/32 nuts, two washers
and base screw from the faucet side car.
• Remove the black silicone grommet.
STEP 5
• Completely remove the faucet side car,
spacer and plate assembly from the left
side of the brewer.
STEP 6
Remove Cover
Remove Hose Snap
Remove Tube
Remove Nuts ,
Washers, Screws
& grommet
Spacer
Plate Assembly
Faucet Side Car