Need help?Do you have a question about the Bunn DUAL SH DBC and is the answer not in the manual?
General| Category | Coffee Maker |
|---|---|
| Manufacturer | Bunn |
| Model | DUAL SH DBC |
| Coffee Type | Ground Coffee |
| Voltage | 120V |
| Material | Stainless Steel |
| Type | Coffee Maker |
| Features | Dual brewing, stainless steel |
Explains the brewer's programmability for various coffee flavors.
Provides critical hazard alerts and precautions for safe operation and handling.
Details the required voltage, amperage, and wiring for electrical hook-up.
Outlines water pressure, pipe size, and connection requirements for plumbing.
Describes the purpose of each button, display, and sensor on the brewer's control panel.
Step-by-step guide for connecting and preparing the brewer for first use.
Details the process for brewing coffee, including filter and grounds preparation.
Provides instructions for routine cleaning of the brewer and sprayhead.
Identifies the five hidden switches used for accessing and navigating programming menus.
Explains the three methods for programming coffee recipes: Smart Funnel, Recipe Card, or Manual.
Configures the brewer to prevent brewing if water temperature is below the set ready temperature.
Allows selection between English and Metric units for display readings, potentially erasing recipes.
Guides the operator through setting brew volumes, bypass, pulse, preinfusion, and drip times for new coffee flavors.
Allows viewing and changing programmed brew settings for existing coffee flavors.
Details how to set or adjust the amount of coffee dispensed per batch.
Explains how to modify the percentage of water that bypasses coffee grounds for flavor tuning.
Configures the sprayhead flow to pulse on and off during brewing for flavor optimization.
A method to set pulse brew times by observing water flow during brewing.
A method to set pulse brew times by manually entering specific durations.
Adjusts the initial water soaking time for coffee grounds before the main brew.
Modifies the duration the funnel lock remains engaged after brew completion.
Transfers brew settings from one side of the brewer to the other for "no-name" coffee flavors.
Controls whether advertising messages are displayed on the brewer when it is not in use.
Adjusts the main brew water temperature in the tank, affecting coffee extraction.
Configures the minimum temperature required for the brewer to indicate "READY TO BREW".
Fine-tunes the water level sensor sensitivity to accommodate varying water conductivities.
Allows viewing and entering the actual flow rate of the sprayhead in ounces per minute.
Allows viewing and entering the actual flow rate of the bypass nozzle in ounces per minute.
Procedure to measure and set the precise flow rate of the sprayhead for accurate brewing.
Procedure to measure and set the precise flow rate of the bypass valve.
Tracks and allows resetting of brew cycles completed on each side and total.
Prevents brewing if a Smart Funnel is not correctly positioned in the funnel rails.
Prevents brewing if a Soft Heat server is not correctly positioned on the brewer.
Guides testing of individual parts like brew valves, heaters, and solenoids.
Verifies the proper operation of all switches on the brewer's control panel.
Checks server detection and the frequency of funnel sensor coils for diagnostics.
Restores all recipes and settings to their original factory-set values.
Provides solutions for common error messages like "OVERFLOW CUP FULL" and "SERVER NOT IN PLACE".
Addresses issues like "NO FUNNEL PRESENT", "TEMPERATURE TOO LOW", and "BREW STOPPED!".
Solves problems related to heating failures, long fill times, and water supply.
Diagnoses spitting, unusual noises, weak beverage, and inconsistent levels due to lime or component issues.
To Next Page
