Page 22
REVIEW RECIPES/MODIFY RECIPES/SET UP NO
NAME COFFEE FLAVORS
This function has three parts. It allows the operator
to view the brew settings for the various coffee names
programmed into the brewer.
It also allows the operator to modify (change) any of
the BREW VOLUMES, BYPASS PERCENTAGES, PULSE
BREW TIMES, PRE-INFUSION TIMES and DRIP-OUT
TIMES for a particular coffee name programmed into
the brewer.
Finally, this function is used to set up the two NO
NAME coffee BREW VOLUMES, BYPASS PERCENT-
AGES, PULSE BREW TIMES, PRE-INFUSION TIMES
and DRIP-OUT TIMES.
Procedure for reviewing recipes:
1. Press and hold upper right hidden switch until the
display reads SET NEW RECIPES. Release switch.
Press and hold upper right hidden switch until the
PROGRAMMING FUNCTIONS -(cont.)
<RECIPE NAME>
MODIFYSHOWNEXT
THAT WAS THE
LAST RECIPE
NO-NAME LEFT
MODIFYSHOWNEXT
REVIEW RECIPES?
NO YES
EXIT TO
NEXT FUNCTION
SCREEN
SCROLLS THROUGH ALL
BREW SETTINGS FOR
NO-NAME LEFT
COFFEE FLAVOR
SCROLLS THROUGH ALL
BREW SETTINGS FOR ANY
OTHER COFFEE FLAVORS
STORED IN BREWER'S MEMORY
SCROLLS THROUGH ALL
BREW SETTINGS FOR ALL
COFFEE FLAVORS IN MEMORY
WHEN IT REACHES LAST
RECIPE IT WILL ADVANCE TO:
P2360
display reads REVIEW RECIPES.
2. Press YES to proceed. The display should now
read NO-NAME LEFT, along with MODIFY, SHOW
and NEXT.
3. Press and release SHOW. The screen will scroll
through all the brew settings for that particular
coffee fl avor name. When fi nished, the display
will return to the coffee name just viewed.
4. To see settings again, press SHOW. To advance
to the next coffee fl avor name, press NEXT.
5. To exit, press NEXT until the display reads THAT
WAS THE LAST RECIPE.
6. After 5 seconds, the display will return to the
REVIEW RECIPES screen. Press and release NO
to advance to the next function screen, or press
and release either of the pads located on the
front switch panel to exit the programming mode
and return to the MAIN SCREEN.
29877.2 121504
To Next Page
Loading...
Need help?
General
