Page 8
COFFEE BREWING (Cont.)
There may be certain situations in which the brew cycle will not begin when BREW is selected:
a. BREW TEMPERATURE TOO LOW - wait until heated, or cancel BREW LOCKOUT option.
b. CHECK FUNNEL - remove funnel, empty previously brewed grounds and replace with fresh.
BREWING WITH A SMART FUNNEL AND G9-2T DBC or MHG GRINDER
1. Select the desired batch size on the grinder.
2. Insert a BUNN filter into the gourmet funnel.
3. Grind the selected amount of fresh coffee into the Smart Funnel using the G9-2T DBC or MHG with Smart
Funnel operation and level the grounds by gently shaking.
4. Slide the funnel into the funnel rails of the selected side. The brewer will read the coffee name and size ground
through the chip in the funnel handle.
NOTE - The brewer will automatically match the brew batch size to the grinder batch size:
GRINDER BREWER
Small Small Batch
Medium Medium Batch
Large Full Batch
*BATCH SIZE NOT ENABLED - If the batch size recorded in the Smart Funnel is not enabled for the recipe
stored in the brewer, you will need to enter into the RECIPES option in programming and verify the correct
batch size is enabled for the coffee name. Refer to the "MODIFYING RECIPES" section for information on how
to enable or disable batch sizes.
*PLEASE VERIFY PARAMETERS - When inserting a Smart Funnel onto the funnel rails, the brewer will
automatically add the coffee name if it doesn't exist in programming. In this event, the display will prompt
the operator to verify that the recipe parameters are correct before starting a brew. Refer to the MODIFYING
RECIPES section for information on how to review and set recipes.
5. Place an empty server under the funnel.
6. Select the START BREW button.
7. The display will read BREWING and show the time remaining in the brew cycle. Select the STOP button to
discontinue the brewing if necessary.
8. Carefully remove the brew funnel and discard the grounds and filter only after visible dripping stops.
TEA BREWING
1. Begin each brew cycle with a clean empty brew funnel and server. (Ensure the server lid doesn’t interfere
with the flow of dilution water coming from the dilution nozzle.)
2. Insert a BUNN filter into the funnel.
3. Pour the packet of loose fresh tea leaves into the filter. Approximately three to five ounces is recommended
for three gallons of beverage.
4. Level the bed of tea leaves by gently shaking.
5. Slide the funnel into the funnel rails until it stops. On dual dilution models, rotate the funnel handle left or
right to align the funnel discharge over the reservoir.
6. Select the desired recipe by selecting the button above the batch selections. If there are more than 6 recipes
stored in the brewer, use the scroll arrow to navigate to the desired recipe.
7. Select the desired batch size for the recipe.
55502 000000
To Next Page
Loading...
Need help?
General
