Bunn NHB - More about Your Brewer; Hot Water Tank

9
MORE ABOUT YOUR BREWER
HOT WATER TANK
• Brewerisdesignedtobepluggedinatalltimes,exceptduringinitialsetupor
when cleaning.
• Thestainlesssteelhotwatertankisdesignedtokeepwaterattheproper
brewing temperature at all times. During a brew cycle, the newest water added
to the tank is heated to proper brewing temperature and held until needed.
• Usevacationswitchtocompletelyshutoffallelectricalcomponentswhen
brewer will not be used for 3 or more days. Safety features built into the
BUNN Velocity Brew make daily use of the vacation switch unnecessary.
• Ifbrewerisshutofforunpluggedforanextendedperiodoftime,allowwater
to heat to the proper temperature before using (about 15 minutes or until the
heating sound stops).
• Ifbrewerhasbeenshutoffanddrainedofallwater,followInitialSetup(page4)
before brewing again. Improper setup will result in permanent damage to your
brewer and void the limited warranty.
GLASS AND THERMAL CARAFES
• NHB,GR,BX–Brewedcoffeeflowsintoaglasscarafeandiskeptatserving
temperature by the porcelain carafe warmer. Warmer is controlled by the on/off
switch at the front of the brewer. NOTE: The warmer switch controls only the
carafe warmer. It is NOT the vacation switch.
• ST,BT–Brewedcoffeeflowsintoanunheatedthermalcarafe.Thedoublewall
stainless steel construction holds coffee at serving temperature for about 2
hours at maximum flavor. Pre-heating (instructions on page 6) carafe with hot
water increases the time coffee stays warm.
ADDITIONAL INFORMATION
• Whenbrewerisnotinoperation,thespinorfliplidshouldbeclosed.Iflidisleft
open, water can drip from the sprayhead when cold water is poured in.
• Hotwaterforcookingmaybedispensedthroughthebrewerwhenthereareno
coffee grounds in the filter basket. Use caution when dispensing hot water from
the brewer. The water is approximately 50°F hotter than a hot water faucet.
• Ifthesprayheadbecomeslooseandneedstoberetightenedwithyour
fingertips, make sure it has cooled sufficiently to avoid burning your fingers.