Bunn SINGLE SH DBC - Page 22

Page 22
PROGRAMMING THE BREWER (cont.)
41341 042712
SET PULSE BREW - EASY METHOD
NOTE: The procedure to enter the PULSE BREW
function must be performed prior to following the
steps listed below.
1. The display should read BREW TIME: X.XX and
a batch size indicator will be flashing.
2. Using (-) and (+), set the desired brew time for
the selected batch size.
3. When finished, select another batch size to be set
by pressing the switch next to the indicator light.
Repeat step 2 for each batch size to be set.
4. When finished setting all batch sizes, press done.
This will display the 1st, OFF, and LAST times for
5 seconds, then advance to 3 BATCHES DONE ?.
5. If the three batch sizes are not correct, press and
release NO to return to SELECT METHOD setup
screen and repeat steps 2 thru 4. If they are cor-
rect, press YES. This will advance to the DRIP
TIME setup. (See DRIP TIME SET UP)
SET PULSE BREW?
NO YES
DRIP TIME XX.X
(-) DONE (+)
SELECT METHOD
EASY NEXT MANUAL
BREW TIME: X:XX
(-) DONE (+)
3 BATCHES DONE?
NO YES
1st OFF LAST
X:XX X:XX X:XX
5 sec delay
EASY SELECTED